Breaching-technologies Explosive Breaching Kit Manual de usuario

BTI Explosive Breaching Stand ManualModel Type: 11BTI Part Number: EBS01 January 20111

10

11Slide the Hinge Bar to the far right position.Move door into position and insert into lock bracket.Loosen all “T” handle clamps.

12Block up the door or have an assistant lift the door so there is about 2” clearance below the door.Tighten the lock clamp.

13Tighten hinge clamps.Securely tighten frame clamps. A box end wrench may be used to ensure that clamps are tight.

14Ready to breach.Hinge clamp and lock clamp “T” handles are on the inside to prevent them from getting caught on clothing or gear during entry.

15Door swings inward – swinging outward will cause interference with the lower frame clamp.

Breaching The Door. Your new breaching door has been engineered to simulate scenarios for forced entry training utilizing explosives. Explosives The

17

Remember that when a detonation occurs, the material used to push the door open is deformed and fragments at a very high velocity. It

WALL INSTALLATION1. Insert Breaching Stand into 48” x 85” opening.2. Breaching Stand is then secured with customer supplied 1/4” lag bolts or similar

WARNING:The Patent Pending BTI Explosive Breaching Stand is a proprietary product and is exclusively offered by BTI for explosive breaching ONL

IMPORTANT NOTICE!!ATTN: BREACHING TRAINERPlease deliver this notice to theBREACHING TRAINERBTI Breaching Doors arerecommended for use in the BTI Explo

4

WARNINGBTI HAS NO CONTROL OVER THE PROPER USE AND INSPECTION OF THIS PRODUCT ONCE IT LEAVES OUR CONTROL. DEATH AND INJURY ARE EASI

ALL CLAIMS, ACTIONS, DAMAGES, LIABILITIES AND EXPENSES (INCLUDING, LEGAL FEES, EXPERT WITNESS FEES, COURT COSTS AND DISBUR

WarrantyYour new BTI Explosive Breaching Stand includes a One Year Warranty against manufacturing defects. Its useful life is

Explosive Breaching Stand OperationYour new breaching stand has been designed to simulate an inwardly opening door for forced entry training utiliz

The BTI Explosive Breaching Stand is designed to hold the target door. At no time should the explosives come in direct contact with the metal frame